Thursday 20 October 2011

USB programmer for Atmel AVR controllers


 USB programmer for Atmel AVR controllers


USBasp Foto

USBasp is a USB in-circuit programmer for Atmel AVR controllers. It simply consists of an ATMega88 or an ATMega8 and a couple of passive components. The programmer uses a firmware-only USB driver, no special USB controller is needed.

Features

  • Works under multiple platforms. Linux, Mac OS X and Windows are tested.
  • No special controllers or smd components are needed.
  • Programming speed is up to 5kBytes/sec.
  • SCK option to support targets with low clock speed (< 1,5MHz).
  • Planned: serial interface to target (e.g. for debugging).

Download

Firmware and circuit

The following packages include circuit and firmware.
usbasp.2011-05-28.tar.gz (519 kB) TPI support (upcoming release of avrdude will use it), supports programmers with ATMega88 and ATMega8.
usbasp.2009-02-28.tar.gz (260 kB)
usbasp.2007-10-23.tar.gz (172 kB)
usbasp.2007-07-23.tar.gz (176 kB)
usbasp.2006-12-29.tar.gz (118 kB) Supports programmers with ATMega48 and ATMega8.
usbasp.2006-09-16.tar.gz (116 kB) New VID/PID!
usbasp.2005-11-14.tar.gz (175 kB)
usbasp.2005-07-03.tar.gz (166 kB)
usbasp.2005-04-21.tar.gz (169 kB)

Please refer to Readme.txt for details on building, installing and using USBasp.

Drivers

On Linux and MacOS X no kernel driver is needed. Windows requires a driver for USBasp:
usbasp-windriver.2011-05-28.zip (70 kB)

Software

Hardware

Schematic







please post your comments


0 comments:

Post a Comment

Note: only a member of this blog may post a comment.

adhitz

Twitter