new site coming soon , 4uguyzz.in
JOIN WITH US ON FACEBOOK
JOIN WITH US ON TWITTER
Wednesday, 23 January 2013
Sunday, 6 January 2013
Motion Sensor
Tag
motion sensor simple schematic
PIR Motion Sensor
SEN-08630
Description: This is a simple to use motion sensor. Power it up and wait 1-2 seconds for the sensor to get a snapshot of the still room. If anything moves after that period, the 'alarm' pin will go low.This unit works great from 5 to 12V (datasheet shows 12V). You can also install a jumper wire past the 5V regulator on board to make this unit work at 3.3V. Sensor uses 1.6mA@3.3V.The alarm pin is an open collector meaning you will need a pull up resistor on the alarm pin. The open drain setup allows multiple motion sensors to be connected on a single input pin. If any of the motion sensors go off, the input pin will be pulled low.The connector is slightly odd but has a 0.1" pitch female connector making it compatible with jumper wires and 0.1" male headers.
Note: The colors of the wires can vary greatly. Looking at the unit from the top, the middle wire is ground, the left-most wire is the alarm, and the right-most is the power.
JOIN WITH US ON FACEBOOK
JOIN WITH US ON TWITTER
motor forward reverse control using relay driver
Tag
JOIN WITH US ON FACEBOOK
JOIN WITH US ON TWITTER
create or convert your site to a mobile site
Tag
CONVERT YOUR WEBSITE TO MOBILE
IN UNDE
IN UNDE
create your own mobile site or convert your site in to mobile site click here ginwiz
JOIN WITH US ON FACEBOOK
JOIN WITH US ON TWITTER
Subscribe to:
Posts (Atom)
